Product Details
| No. | Name | Function | Material |
| 1 | Top Fabric
| Protect the lining tensile member
| Polyester Cotton Canvas
|
| 2 | Buffer Rubber
| Support and protect the adhesive force of the tensile member
| CR |
| 3 | Tensile member
| Critical material to pass the dynamic force and endure high shock load
| Polyester |
| 4 | Bottom Rubber
| Maintain the shape of the rubber and improve its side compression ability and wear-ability
| CR |
Install Method of Transmission Belt
Shutting down the equipment,losen the bolts,remove the belt: Tum off the power,remove the protective cover. Loosen the bolts on the pedestal, So that the motor can move back and forth.Move the motor, remove belt from pulley.
Check the old belt and pulleys: Check whether there is abnormal wear on the old belt in order to confirm the maintenance of the gear, check whether there are cracks or breakages in the pulley.If its worn too much, you must replace the pulley.
Check the old components,align the pulleys: Check other components of the gear, such as the symmetry, wear and lubrication of the bearings and bushings, to ensure that the pulley grooves parallel to each other.
Install the new belt: Locate the belt on drive pulley ,turn the pulleys slowly to facilitate installation.
Check the belt tension: Tighten the gear center distance, hand- -turn the driving wheel for a few laps. Check whether the belt tension is appropriate by a tension gauge. Tighten the bolts of the motor with required torque.
Debugging and adjustment, lubricate correctly: start up the gear, run under full load conditions. Keep observing to see whether any abnormal vibration,noise occurs in the commissioning process. Shut down the equipment after running for some time and heck the heat conditions of bearings and motor. Too hot means too tight tension or bearing asymmetry, or lubrication is not correct. Stop debugging when the belt has completely consistent with the pulley grooves,check and adjust the tension to recommended value.
Product Features
CR V-Ribbed belt has excellent heat and oil resistant
Not only bear to bend ,but also bear the ozone aging better than general unsaturated rubber
High transmission efficiency under the operating environment of high-speed rotation ,reverse flexure ,small band pulley
Bearing higher horizontal pressure ,incrementing to bear to press function ,decreasing the stress deformation after adding short fiber reinforcement.
The order quantity should not be less than 100 pieces
Maintenance
Belt should be kept at room temperature, avoid direct sunlight, rain and show shower, keep clean. Belts should be hung on brackets or lie on the shelf, not directly on the ground.
Property placed to avoid excessive compression and deformation.
Cautions for belts Application
Please pay attention to your dressings for the rotating part including belt wheel may wrap your hair, gloves or clothes.
Stop operation and confirm the belt is stopped before you repair,inspect or replace parts. Never cut out belt using knives or scissors if the belt is in tension status,otherwise it may cause broken-up and result in injury.
Never touch the belt or belt wheel immediately after the equipment is stopped,or you may be scalded. Please release the tension before replacing belts,or it may result in breakage of belt.
Maintain specified tension during installation and operation,or it may cause noise or even breakage. Please replace all belts if more than one belt is installed on a belt wheel,or it may result in breakage of belt.