Product Details
| No. | Name | Function | Material |
| 1 | Top Fabric
| Protect the lining tensile member
| Polyester Cotton Canvas
|
| 2 | Buffer Rubber
| Support and protect the adhesive force of the tensile member
| CR |
| 3 | Tensile member
| Critical material to pass the dynamic force and endure high shock load
| Polyester |
| 4 | Bottom Rubber
| Maintain the shape of the rubber and improve its side compression ability and wear-ability
| CR |
Application Faults and solutions for V-Ribbed belts and V belts
Appearance:serious cleavage in a certain spacing Cause: undersized diameter of belt wheel power transmission at high temperature There is dust or chemical substances on gear Solution：Increase diameter of belt wheel or redesign transmission load improve ventilation Use proper protective device Appearance : Minor cleavage occurred unevenly Cause:Belt used for too long time Solution：replace belt Appearance : disconnection of belt Cause:Overload or shock loading extraneous material in gearing tensile cord damaged Solution：redesign transmission load ,use proper belt protective device,observe correct belt installation sequence Appearance : there is brightness or flash on the side of belt Cause:Oil pollution,Belt slips Solution：detoxify oil readout belt tension Appearance : secession of belt layer Cause: Oil pollution,Belt slipping or insufficient tension, dis alignment of shaft line , undersized diameter of belt wheel Solution：detoxify oil ,readjust the tension of belt,confirm if the shaft line of belt wheel is in coincidence and make some modification increase diameter of belt wheel or confirm the transmission load Appearance : abrasion of the side of belt Cause:Belt wheel abrasion or surface asperity of belt ,wheel,belt slips,dis alignment of shaft line , Incorrect specification of belt Solution：replace belt wheel readjust the tension of belt confirm if the shaft line of belt wheel is in coincidence and make some modification ,replace with belt in correct specification Appearance : abrasion of the upper side of belt Cause:Mutual interference between belt and protective device,Incorrect hanging of belt wheel,Undersized belt Solution：replace ,repair or redesign belt protective device install belt on the belt wheel correctly, use a belt proper to the belt wheel Appearance : abrasion of the bottom side of belt Cause:Sink of belt,oil pollution ,incorrect hanging of belt on belt wheel Solution：replace belt,hang belt on the beltProduct Features
CR V-Ribbed belt has excellent heat and oil resistant Not only bear to bend ,but also bear the ozone aging better than general unsaturated rubber High transmission efficiency under the operating environment of high-speed rotation ,reverse flexure ,small band pulley Bearing higher horizontal pressure ,incrementing to bear to press function ,decreasing the stress deformation after adding short fiber reinforcement. The order quantity should not be less than 100 piecesProduct Display
